Laying method

Carpets come in two forms: block carpets and roll carpets, using different laying methods and positions.

Active laying: It refers to placing the carpet openly on the base layer without fixing it to the base layer.

Fixed laying: There are two fixing methods for fixed laying. One is the card type fixing, which uses a barbed board to pull the carpet; One method is adhesive fixation, which uses adhesive to stick the carpet to the floor.

The basic process of carpet floor decoration is to use a card type fixing method, which involves cleaning and processing the base layer, cutting the carpet, nailing and barbed boards, laying the cushion layer, seams, flattening, fixing the carpet, trimming, repairing the carpet surface, and cleaning.

Adhesive method fixation method: grassroots ground treatment → actual measurement and laying out → cutting carpet → scraping and drying → laying silver pressure → cleaning and protection.

The key points of construction must be measured before paving, measuring whether the wall corners are square and accurately recording the angles of each corner. Draw lines and cut on the back of the carpet based on the calculated cutting size; Fixed installation of barbed boards with barbed boards nailed along the wall edge, with the barbed board 8 millimeters away from the skirting board; Apply adhesive tape to the back of the carpet at the seams to stick two carpets together. First, trim the uneven fuzz at the seams and repeatedly rub the fuzz at the seams until no visible seam marks are visible on the surface; When bonding and laying, scrape the adhesive and let it air dry for 5-10 minutes. When the adhesive becomes dry and sticky, lay it; After laying the carpet, use support needles to tighten and flatten the carpet, and hang it on a barbed board. Glue the carpet and use a felt roller to press out bubbles after laying it flat; Cut off excess carpet edges and clean the fibers that have been pulled off; When cutting carpets, the warp and weft yarns should be cut along the carpet, only the weft yarns should be cut, and the warp yarns should not be cut. For carpets with backing, the fuzz should be separated from the front, and the warp and weft yarns should be found before cutting.

Attention should be paid to the protection of finished products. Carpets pasted with adhesive should not be stepped on randomly within 24 hours; Carpet paving has high requirements for the base floor, which must be flat and clean, with a moisture content not exceeding 8%. Skirting boards have been installed, and the gap between the lower edge of the baseboard and the ground should be 2-3 millimeters larger than the thickness of the carpet; Accurately measure room dimensions and calculate cutting dimensions to avoid waste; After laying the carpet, it is necessary to tighten, level, and fix it to prevent deformation in the future.